KB: Error message when you try to install System Center 2012 Endpoint Protection for Mac: "There were errors with the installation"

This Knowledge Base article talks about an issue where installing System Center 2012 Endpoint Protection for Mac fails with “There were errors with the installation" :

Symptoms

When you try to install Microsoft System Center 2012 Endpoint Protection for Mac (SCEP), you receive an error message that resembles the following:

There were errors with the installation. You may want to try installing again.
The Installation failed.

Resolution

To resolve this issue, use the following methods. If Method 1 does not resolve the issue, go to Method 2:

Method 1

1. Click Close to close the error message window.
2. On the Go menu, click Applications.
3. Double-click System Center 2012 Endpoint Protection for Mac.
4. Verify that System Center 2012 Endpoint Protection for Mac starts as expected. To do this, click the System Center Endpoint Protection for Mac icon in the menu bar, and then click Open System Center 2012 Endpoint Protection.

Method 2

If System Center 2012 Endpoint Protection for Mac does not start as expected, follow these steps:
1. Restart the system into safe mode
2. Delete all SCEP applications bundles from /Application folder that you can found in it
3. Make a normal restart
4. Run 4.5.9X Uninstaller from 4.5.X dmg
5. execute from Terminal: rm -Rf ~/.scep/
6. cd /Library/Application\ Support/Microsoft/
7. sudo rm -Rf *scep/

NOTE: install.log can be found at /var/log/install.log